3/4" Female Hex

For light machining of thin walled or plastic parts where only minimal pressure is necessary.

The Calibration Gauge reads the actual pressure or force at the vise jaws that hold the work piece.
We recommend using the Calibration Gauge with the Repeater Vise Handle to verify pressure settings, allowing for minor differences between Repeaters and between vises.
Note the psi reading on your traveler so you can set your Repeater on your next run.

This product can also be used as a force gauge in a vise or other fixture. Has a 1/4-20 threaded hole in the piston for mounting tooling.

Available with 400, 600, 1000, 1500, 2000, 3000 and 5000 psi gauges

Please Note: We are phasing out these Repeater models - only one each available

Adjustable Torque
Eliminate Part Deflection
Clutch disengages when set pressure is reached
Repeatable clamping every time
One tool clamps and releases

If you are not sure of the torque or pressure range to order and cannot determine it with a standard torque wrench we recommend using our Calibration Gauge.
The Calibration Gauge reads the actual pressure or force at the vise jaws that hold the work piece. Torque is a rotational force that depending on the pitch and size of the lead screw and the wear on the vise components can affect the pressure at the jaws. Therefore we recommend using pressure on the work piece to determine the vise handle setting.

Adjustable Torque
Eliminate Part Deflection
Clutch disengages when set pressure is reached
Repeatable clamping every time
One tool clamps and releases

If you are not sure of the torque or pressure range to order and cannot determine it with a standard torque wrench we recommend using our Calibration Gauge.
The Calibration Gauge reads the actual pressure or force at the vise jaws that hold the work piece. Torque is a rotational force that depending on the pitch and size of the lead screw and the wear on the vise components can affect the pressure at the jaws. Therefore we recommend using pressure on the work piece to determine the vise handle setting.